Quality Jefferson GA septic system installers do a lot of legwork, long before a unit gets put into the ground. A new unit will last years, and possibly even generations, if it’s placed properly, but it can fail instantaneously if it’s not. Additionally, all Jefferson GA septic system installers must obtain a permit in order to perform the install, and may ought to coordinate with city or county officials to show that particular tests were performed in order to continue. These three assessments are important first steps that should always be taken before any job or designs are done, and it may also be helpful to do them before you acquire a property, so you could be assured that a tank and leach field will be allowed.
1. Pit
The pit test is pretty uncomplicated. During this test, a hole is dug and the soil is analyzed to figure out its structure. A conventional leach field is reliant on the soil’s structure to drain effectively. If there is a lot of gravel or sand, your leach field should be ready to discharge the effluent (water) from the tank well, where the soil will finish sanitizing it. If the soil has a bunch of clay or rock, it won’t drain well, consequently a traditional leach field will not be an alternative. If the site you’ve picked does not pass the pit test, you may be able to pick another site on your property or use an alternate kind of drain field, such as a mound system.
2. Perc
The perc, or percolation test, involves excavating a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then filling it with water. The hole is commonly left saturated for about two hours, and refilled as needed. After this, the hole is filled with 6 inches of water and monitored for water drainage.
3. Visual
There are several things an inspector will check into visually. Many units are gravity-fed, so they don’t depend on electricity or pumps to move effluent from the tank to the leach field. Because of this, the incline of the ground is very important. An inspector will also seek out slopes that could feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Hire Quality Jefferson GA Septic System Installers Today
Selecting the right design, type of system, and assessing the land correctly, are all essential procedures in making sure an install goes off without a hitch. Most significantly, these steps ensure that the install is done properly, so that a system provides decades of use without issue. If you’re preparing for an install, contact Septic Tank Pros Flowery Branch. Our professionals are knowledgeable and devoted to quality, so you could be sure the job is done right. Call (470) 798-3733 now.