Quality Johns Creek GA septic system installers do a lot of legwork, long before a unit gets placed into the ground. A new unit will last many years, and possibly even generations, if it’s installed properly, but it can fall short instantly if it’s not. On top of that, all Johns Creek GA septic system installers must secure a permit in order to carry out the install, and may ought to partner with city or county officials to show that certain tests were done in order to progress. These three tests are necessary initial steps that should always be taken before any job or designs are done, and it may also be advantageous to perform them before you purchase a property, so you could be assured that a tank and leach field will be permitted.
1. Pit
The pit test is relatively straightforward. In the course of this test, a hole is dug down and the soil is analyzed to establish its structure. A typical leach field is dependent on the soil’s structure to drain efficiently. If there is a lot of gravel or sand, your leach field should be able to discharge the effluent (water) from the tank well, where the soil will finish cleaning it. If the soil has a considerable amount of clay or rock, it won’t sink well, consequently a standard leach field will not be an option. If the location you’ve selected does not pass the pit test, you may be able to select another site on your house or use an alternate kind of drain field, like a mound system.
2. Perc
The perc, or percolation test, involves digging a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then filling it with water. The hole is commonly left drenched for about two hours, and refilled as needed. After this, the hole is filled with 6 inches of water and monitored for drainage.
3. Visual
There are numerous things an inspector will check into visually. Most units are gravity-fed, so they don’t rely on electricity or pumps to shift effluent from the tank to the leach field. As a result of this, the incline of the ground is vital. An inspector will also look for slopes that can feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Enlist the Services of Quality Johns Creek GA Septic System Installers Today
Choosing the right configuration, type of system, and evaluating the land effectively, are all integral steps in making sure an install goes off without a hitch. Most importantly, these steps ensure that the install is done correctly, so that a system provides years of use without issue. If you’re preparing for an install, contact Septic Tank Pros Flowery Branch. Our technicians are knowledgeable and committed to quality, so you could be sure the job is done right. Call (470) 798-3733 now.